Boiler

Six days this month, Changsha, Hunan Furong District Arts Road street to carry out special safety inspection of horizontal boiler seller in asias.

Inspectors focus on examination of the health and safety management of boiler equipment, whether or not the gas boiler passed the test, whether to establish safety management systems and procedures, whether set the security authorities, whether with full-time security officer, determines whether the operator a valid work permit for employment, boiler operating records, inspection records and shift records are complete and so a detailed investigation, while eliminating the risk management and operational aspects of the boiler in existence.

In this inspection, the implementation of the following three major check the contents.

First, we must implement the main responsibility for security, strictly abide by relevant laws and regulations and safety specifications, and resolutely put an end to illegal operation, strengthen the management and monitoring of equipment, hazard, earnestly implement the responsibility to the people, and ensure safe and reliable operation of special equipment.

The second is to strengthen the advocacy training for boiler operators to improve their ability to deal with emergency breakdown or accidents, improve safety awareness boiler operator, firmly establish the concept of safety first, to ensure the safe operation of the boiler.

Third, low nitrogen and urge reconstruction work carried out boilers to reduce nitrogen oxide emissions, reduce concentration of nitrogen oxides, air pollution prevention.

Water supply system steam horizontal boiler seller in asia system is fully automated raw material throat steam boiler, steam drying steady flow supplied to the user. When the water into the tank, the power switch, controlled by the drive signal, high temperature solenoid valve is opened, the pump work, is injected through the check valve furnace. When the solenoid valve, the check valve is clogged or damaged, steam boiler feed water reaches a certain pressure through the pressure relief valve overflow back into the tank, to protect the pump. Intake air not only water, as long as the rapid exhaust through the exhaust valve until the discharge water, close the exhaust valve, pump work properly. The main water supply system component is the pump, they use a multi-stage vortex pump of higher pressure and a larger flow rate, a small portion of the vane pump using a diaphragm pump or a steam boiler is mainly composed of biomass supply system, automatic control system, heating system and furnace and security systems and other components. Generator controlled level controller is the central nervous system, electronic and mechanical into two categories. Electronic probe electrode level controllers by three different high and low control level (i.e., the difference in height level) so as to control the heating time of the water supply pump and the furnace heating system, working pressure is stable, broad range of applications .

6 tons of steam horizontal boiler seller in asia maintenance procedures introduced 1, boiler during operation should pay attention to the following points: (1) does not allow pressurized combustion furnace flame, or easy to damage the door, watching the fire door and unsafe. (2) should be regularly blower, fan, electric water pump fuel. (3) It should be noted arch brick without loss, with or without overflow wall furnace fire phenomenon, identify problems and timely repair, repair shutdown if necessary. The bottom surface (4) shall boiler water to prevent corrosion of the base. (5) The class filter at least once to open check. 2, 2 a boiler operation three weeks should carry out a check. (L) before opening the flue, if smoke tube fouling should be removed, such as less fouling or non-fouling, cleaning time may be the Director, opened once a month, if still no fouling extended 2-3 May start time, checking after each turn, must be locked, shall not leak smoke. (2) Open once each class cleaning door, cleared out the gray tone, without fouling or fill extend cleaning time, according to the actual situation in the hands of fireman, and explore the experience. (3) water gauge, valves, piping, flanges, etc. should be repaired as steam leakage. (4) boiler 2 to 3 months, to the water wall, pipe and be cleared of soot ignition face. Run 3 to 6 months after the shutdown should be all inspection and maintenance. (5) inside and outside of the boiler inspection, such as the partial pressure weld steel corrosion; If it is found serious deficiencies should be repaired, if the defect can not leave shutdown repair, found suspicious, but does not affect when production safety, records should be made for reference during processing. (6) can be checked and the coated portion of the boiler water to prevent corrosion paint. (7) if necessary insulation furnace wall outer casing removed to provide a thorough examination of the prior seriously damaged portion, only after continued use must be rehabilitated, checked and repaired while the person filling the case of the present security technology registration boiler. (8) housing the heat insulation layer (outer sheath), a paint duct at least a year. (9) Maintenance of long-term without the boiler, dry and wet, dry application shutdown more than a month, the following month shutdown can be used wet maintenance method.

Boiler oven on those things: binding horizontal boiler seller in asia structural characteristics of view, more suitable flame oven method, in order to avoid damage to the oven before, need covered with a layer of slag at the bottom grate; then boiler combustion chamber firewood stack frame, so that it will ignite after the flame is maintained at a central location, similar to the state to keep for several days.